How to Choose a Nail Dust Collector: Cordless or Plug-In, Filters and Masks
By Edmond Lin, over 10 years in the nail industry, M1 Nail & Beauty Supply, Markham ON · Last updated: November 16, 2026
Pick a nail dust collector by where you work: a plug-in model for a manicure table that runs all day, a rechargeable one if it has to move to a pedicure chair or a client's home, and a palm-sized USB model for a small desk. Then make sure you can buy its filter, and keep your mask. A collector catches filing dust at the table, and OSHA says a dust mask such as an N95 can still help when you file artificial nails.
In this guide
- What does a nail dust collector do?
- Should you buy a cordless or plug-in dust collector?
- How do the nail dust collectors at M1 compare?
- Which filter fits your dust collector?
- How often should you change a nail dust collector filter?
- Where should the dust collector sit?
- Can you use a dust collector for pedicures?
- Do you still need a mask with a dust collector?
- Which nail dust collector should you pick?
- Frequently asked questions
- Related guides
What does a nail dust collector do?
It is a small fan and filter that sits on the table under the client's hand. The fan pulls filing and drilling dust down through a grille into the filter, so less of it ends up on the table, your clothes and in the air. U.S. government guides for nail salons call for dust control at the work table. The EPA says to "install a local exhaust ventilation system near work tables" that can "effectively capture vapors and dust."
A tabletop collector is one part of that. It works only on the dust that reaches its intake, and its filter is made for dust. Keep the room ventilated as well, and wear a mask for heavy filing (see below).
Should you buy a cordless or plug-in dust collector?
Plug-in suits a fixed manicure table. It runs as long as the salon is open and never stops halfway through a set because the battery ran down. Rechargeable suits work away from an outlet: a pedicure chair, a second table, or a mobile kit. Check the run time against your longest day.
The two ONME DC5 models show the trade-off clearly. ONME lists the same 24 W fan, 3,500 RPM and 270 × 200 × 60 mm body for both. The DC5 Bat adds a 14.8 V 2600 mAh battery that runs about 3 hours on a charge; the DC5 Cord has no battery and runs on its 24 V 1.0 A adapter.
How do the nail dust collectors at M1 compare?
These are the specs each maker publishes, with their units.
| Collector | Power | Battery | Fan | Controls | Size |
|---|---|---|---|---|---|
| ONME DC5 Bat | Rechargeable; 17 V 1.4 A charger | 14.8 V 2600 mAh; about 2.5 h to charge, about 3 h of use | 24 W, 3,500 RPM, air speed up to 4.5 m/s | Knob with LED display: 0–30, High Power 0–40 | 270 × 200 × 60 mm |
| ONME DC5 Cord | Plug-in; 24 V 1.0 A adapter | None | 24 W, 3,500 RPM, air speed up to 4.5 m/s | Knob with LED display: 0–30, High Power 0–40 | 270 × 200 × 60 mm |
| AMDMG GM2 | Rechargeable | 5,200 mAh; 4 h to charge, 6 h of use | Brushless turbo fan, 6,000 RPM | Dial with LED display | 19.7 × 15.2 × 4.4 cm (7.75 × 6 × 1.75 in) |
| AMDMG G340-Mini | USB cable; DC 5 V 3 A or 12 V adapter | None | Brushless 15 W, 6,000 RPM | Stepless side dial | 13.9 × 13.8 × 4.0 cm (5.47 × 5.45 × 1.59 in) |
| ONAIL Tornado No.1 | Plug-in; 12 V 2.5 A adapter, USB-C input | None | 360° surround suction | Power switch and +/− buttons, 4 suction levels | 254 × 123 mm, 1,053 g |
All five are tabletop units. The G340-Mini is the smallest and carries by its strap; the DC5 pair are the largest and have a stainless steel honeycomb panel over the filter. The Tornado No.1 comes with 30 disposable filters in the box.
Which filter fits your dust collector?
Use the filter made for your model, and check that you can buy it before you buy the collector. These are the filters we carry:
| Filter | Fits | How to use it |
|---|---|---|
| Nail Vacuum Filter for ONME DC5 | ONME DC5 Bat and DC5 Cord | Non-woven filter under the steel panel, handle side up |
| ONAIL Replacement Filters, 30 pcs | ONAIL Tornado No.1 | Disposable; ONAIL makes them for its dust collectors |
| Nail Vacuum Filter 194mm for X15 | X15 collector | 194 × 194 × 7 mm |
| Nail Vacuum Filter with Frame | Ask us which collector | 7 × 7 × 0.3 in |
| Disposable paper filters, 100 pcs | Laid on top of a collector | 19.3 × 24 cm sheets; replace a sheet when it gets dirty |
Both AMDMG collectors need filter cotton: AMDMG says the GM2 and G340-Mini must be used with it. Ask us in store which pad fits.
How often should you change a nail dust collector filter?
Change it when suction drops, and by the maker's schedule. ONME recommends a new DC5 filter at least every 2 months, before dust cuts the airflow and holds bacteria, and its manual says not to rinse the filter with water. The EPA gives the same rule for salon filters in general: replace them "regularly and according to the manufacturer's directions. If filters are not replaced, they will become ineffective."
Between filter changes, brush the dust off the grille and the table with a dust cleaning brush, and keep a spare filter at the station.
Where should the dust collector sit?
Right under the hand you are filing, as close to the nail as the client is comfortable with, so dust falls into the intake before it spreads. Keep the top clear: the EPA tells salons to keep ventilated tables free of "obstructions, e.g., towels," and a towel over a collector's grille blocks it the same way.
On the DC5, check that a filter is in place before you switch on, then turn the knob clockwise to start and raise the speed. Hold the touch button for 2 seconds for High Power mode, and tap it to pause.
Can you use a dust collector for pedicures?
Yes, if you can place it close to the foot you are working on. A rechargeable model is easier at a pedicure chair because there is no cord to run: the DC5 Bat gives about 3 hours of use per charge and AMDMG lists 6 hours for the GM2. A plug-in model works too if there is an outlet next to the chair.
Do you still need a mask with a dust collector?
Wear one when you file or buff artificial nails. OSHA says a NIOSH-approved filtering facepiece respirator, such as an N95, "may be helpful when you are: Buffing or filing artificial nails; or Using acrylic powders." The EPA also lists "when filing or shaping artificial nail enhancements" as the time to wear a dust mask.
- Paper or cloth medical masks are not enough. OSHA says they "are not the same as dust masks" and "will not protect you from breathing in harmful gases, vapors, or dusts."
- An N95 is for dust, not fumes. OSHA says it will not "protect you from vapors or gases." For product vapours, the EPA calls adequate ventilation "the most feasible way of protecting nail salon workers."
- Cover up. OSHA suggests long sleeves and pants or skirts that are at least knee-length "to protect your lap from acrylic nail and other dusts."
Which nail dust collector should you pick?
| Where you work | Collector | Why |
|---|---|---|
| One manicure table, all day | ONME DC5 Cord or ONAIL Tornado No.1 | Plug-in, no battery to recharge |
| Table and pedicure chair | ONME DC5 Bat | Same fan and size as the DC5 Cord, about 3 hours per charge |
| Mobile or home visits | AMDMG GM2 | Rechargeable, smaller, 6 hours of use (AMDMG) |
| Small desk, students, travel | AMDMG G340-Mini | Palm-sized, USB powered, strap to carry |
Pair the collector with your e-file. For AMDMG's two drills and how they match these collectors, see AMDMG D460 vs D210 Pro.
Frequently asked questions
How often should I change a nail dust collector filter?
When suction drops, and at least as often as the maker says. ONME recommends a new DC5 filter at least every 2 months. Keep a spare at the station.
Can I wash a nail dust collector filter?
Not the ONME DC5 filter: the manual says not to rinse it with water. Replace it instead. For other models, follow the maker's instructions.
How long does a rechargeable nail dust collector run?
ONME gives about 3 hours per charge for the DC5 Bat, after about 2.5 hours of charging. AMDMG gives 6 hours of use for the GM2 after a 4-hour charge.
Does the AMDMG G340-Mini have a battery?
No. It runs on a USB cable from a 5 V 3 A or 12 V adapter. For a cordless AMDMG collector, see the GM2.
Do I still need a mask if I use a dust collector?
Wear one when you file or buff artificial nails or use acrylic powders. OSHA and the EPA point to a NIOSH-approved dust mask such as an N95. A paper medical mask does not stop dust.
What are the paper filter sheets for?
Lay a sheet on top of the collector to catch dust and replace it when it gets dirty. Each bag holds 100 sheets of 19.3 × 24 cm.
See all nail dust collectors and filters at M1, in our Markham store or online.
Shop dust collectorsRelated guides
Sources
- U.S. OSHA, Stay Healthy and Safe While Giving Manicures and Pedicures: A Guide for Nail Salon Workers (OSHA 3542)
- U.S. EPA, Protecting the Health of Nail Salon Workers (EPA 744-F-07-001)
- ONME, DC5 Bat and DC5 user manuals
- AMDMG, G340mini nail dust collector, and AMDMG's official Tmall store listings for the G340 mini and GM2
- ONAIL, Tornado No.1 nail dust collector and replacement filters
